Thread
:
Jolla OtherHalf eInk/ePaper display
View Single Post
kimmoli
2014-02-03 , 21:48
Posts: 562 | Thanked: 2,744 times | Joined on Dec 2013 @ Espoo, Finland
#
30
back to this project while waiting prints...
Got one loose 2.7" display today and breakout board.
Then need to pick a microcontroller to do the job. atmega328 or any other used on arduino would be easy as has most of the sw ready. but i have something personal against atmel. maybe i will make testing with
teensy 3.1
which i should have few somewhere.
This is familiar to me, supports most of the arduino libraries. Programming firmware to the K20 used on teensy custom designs requires auxiliary cpu, but it can be hooked on programming adapter (this is the small MINI54 on the lower left corner)
Have to check memory requirements of used libs, but this has 256kB flash and 64kB ram (compared to atmega328 32kB flash and 2kB ram) so maybe no sd card needed...
below is first block-diagram.
Attached Images
__________________
TOH ideas, concepts and creations since 2013
toholed
tohuart
toheink
Heebo
tohIRi
i2ctool
tohmm
LeTOH
FMTOH
Quote & Reply
|
The Following 8 Users Say Thank You to kimmoli For This Useful Post:
Bundyo
,
Daneel
,
juiceme
,
Kabouik
,
ljo
,
TeHeR
,
tigre-bleu
,
Wikiwide
kimmoli
View Public Profile
Send a private message to kimmoli
Visit kimmoli's homepage!
Find all posts by kimmoli