Thread: Problems with N900 USB port becoming broken / loose and resulting warranty & repair issues
View Single Post
GluonBall is offline GluonBall
2011-10-05 , 12:37
Posts: 8 | Thanked: 0 times | Joined on Jun 2011
#2400
Originally Posted by abill_uk View Post
You have not soldered the port in properly, you need to do a check of your solder work because it is clear the rear pins are not making with the board and if you cannot get the solder from the pins to the through hole solder then you must hard wire with link wire back to the components re the diagram that is also very clear.
abill_uk, thank you for you response.
I will check the connections again, however, I do not believe that it will help.
1.) Phone does charge, when plugged into wall charger while booting, so GND and +5V are ok
2.) If booting unplugged, I can transfer files in mass storage mode, so Data+ and Data- are ok.
Thats why, I would think it is something more complicated.
Sorry, if I miss something obvious.