I've been going through the code and don't see anything obvious; does anyone know if there's any way to raise the bluetooth chip's power output?
Is it a hardware parameter, or perhaps in the firmware?
It would be great to raise it a few mW as it's just not quite enough for outdoor bluetooth audio.
Edit - Does anyone know for certain if the n900's bluetooth chip supports class-1 mode @ 100mW? Is there something special that has to be done to enable it, and will it work with any "v2.1EDR" device?
Is it a hardware parameter, or perhaps in the firmware?
It would be great to raise it a few mW as it's just not quite enough for outdoor bluetooth audio.
Edit - Does anyone know for certain if the n900's bluetooth chip supports class-1 mode @ 100mW? Is there something special that has to be done to enable it, and will it work with any "v2.1EDR" device?
Last edited by nightfire; 2010-04-19 at 20:06.