|
2006-09-16
, 08:52
|
|
Posts: 3,220 |
Thanked: 326 times |
Joined on Oct 2005
@ "Almost there!" (Monte Christo, Count of)
|
#22
|
As to a repeater, building one is trivial. You can simply buy two D-link G730AP (cheap, small, can be run on external batteries available for the Sony PSP portable), use them in access point mode and connect them via an ethernet cable.
|
2006-09-16
, 14:11
|
Posts: 477 |
Thanked: 118 times |
Joined on Dec 2005
@ Munich, Germany
|
#23
|
|
2006-09-16
, 22:05
|
|
Posts: 2,853 |
Thanked: 968 times |
Joined on Nov 2005
|
#24
|
|
2006-09-17
, 06:39
|
Posts: 477 |
Thanked: 118 times |
Joined on Dec 2005
@ Munich, Germany
|
#25
|
Do you have a link to a site or page that describes such a setup in more detail (AP setup & such) ? TIA...
|
2006-09-17
, 08:49
|
|
Posts: 2,853 |
Thanked: 968 times |
Joined on Nov 2005
|
#26
|
|
2006-09-17
, 11:05
|
Posts: 477 |
Thanked: 118 times |
Joined on Dec 2005
@ Munich, Germany
|
#27
|
|
2006-09-17
, 13:06
|
Posts: 190 |
Thanked: 21 times |
Joined on Sep 2006
|
#28
|
I see.
SSID and channels need to be different.
|
2006-09-17
, 13:12
|
|
Posts: 2,853 |
Thanked: 968 times |
Joined on Nov 2005
|
#29
|
|
2007-03-05
, 14:41
|
|
Posts: 14 |
Thanked: 1 time |
Joined on Jul 2006
|
#30
|
The Following User Says Thank You to Maemorandum For This Useful Post: | ||
Exchanging the antenna is obviously possible, but difficult. Everyone can see how to disassemble the 770 on
http://www.uselessinfo.pwp.blueyonde...mantlen770.htm
On the same site, the antenna pictures make it clear that the antenna is connected by 2 spring contacts, so the connector should come in place of them.
BTW: solder does not conduct very well at 2.4 GHz, so an external connector should be attached without solder.
And: the built-in antenna is also used for bluetooth, so the antenna replacement should also be used for bluetooth.
As to a repeater, building one is trivial. You can simply buy two D-link G730AP (cheap, small, can be run on external batteries available for the Sony PSP portable), use them in access point mode and connect them via an ethernet cable.